Skip Ribbon Commands
Skip to main content
Aviation Accident

Quick Launch

NTSB Identification: CEN18LA290
14 CFR Part 91: General Aviation
Accident occurred Friday, July 20, 2018 in Todd Mission, TX
Aircraft: Bell 206, registration: N352CT
Injuries: 2 Minor, 2 Uninjured.

This is preliminary information, subject to change, and may contain errors. Any errors in this report will be corrected when the final report has been completed. NTSB investigators may not have traveled in support of this investigation and used data provided by various sources to prepare this aircraft accident report.

On July 20, 2018, about 1215 central daylight time, a high skid-equipped Bell 206B helicopter, N325CT, lost control after takeoff and impacted terrain near Todd Mission, Texas. The right seat private helicopter pilot and one passenger sustained minor injuries, and two passengers sustained no injury. The helicopter sustained substantial damage. The helicopter was registered to and operated by the pilot under the provisions of Title 14 Code of Federal Regulations Part 91 as a visual flight rules personal sightseeing flight. Visual meteorological conditions prevailed at the time of the accident, and no flight plan was filed. The flight originated from the pilot's private helipad in Pinehurst, Texas, about 0900.

In a conversation with the National Transportation Safety Board investigator-in-charge on July 24, the pilot reported that the purpose of the local area flight was for sightseeing with a family member and friends. After flying in the local area and refueling, the pilot landed on a grass field to facilitate the passengers switching their seat positions in the helicopter. During the seat switching process, the pilot reduced the throttle to the flight idle position. After the passengers switched seats and secured their restraint systems, with one passenger stationed in the front left seat, and two passengers stationed in the cabin, the pilot increased the throttle to 100 percent and lifted off from the field.

About 3 seconds after liftoff, and about 15 feet above ground level with about 5 knots of forward airspeed and heading about 270 degrees, the helicopter made 4 360-degree revolutions to the right. The pilot reported she applied full left pedal with no response from the helicopter. During the loss of control sequence, the pilot observed the torque gauge "jump" and she heard a "whining" noise emit from the engine. Prior to the helicopter impacting terrain, the pilot reduced the throttle to the flight idle position. The left skid impacted the ground, the helicopter rolled to the left, and came to rest on the left side of the fuselage. The pilot executed an emergency shutdown and the occupants egressed from the helicopter without further incident.



After egressing from the helicopter, the occupants were located in an area with adequate cellular phone reception and contacted first responders for assistance. The helicopter was not equipped with an emergency locator transmitter, nor was it required to be.

The helicopter sustained substantial damage to the main rotor system, the fuselage, the tailboom, and the tail rotor system. The pilot reported that there were no preexisting mechanical malfunctions or failures with the airframe and engine that would have precluded normal operation.

The helicopter was recovered from the field and transported to a secure facility for a future examination of the airframe and engine.

The 5-seat capacity helicopter, serial number 340, was built in 1969. The helicopter was powered by a 400 horsepower Rolls-Royce 250-C20 turboshaft engine, serial number CAE801330.